CFV 100C
User Manual
CONTENTS
28
A
B
A small modification to the previous
generations of the camera is required when
using with the CFV. A modified 200 camera
should use the 200 Modified setting. An
unmodified 200 camera must use the 200
setting. A 2000 camera requires the 2000
setting.
• A camera that has been modified is
identified by a label on its left side as
shown in (A).
• The camera cannot read the ISO value set
on the CFV. If using any automatic mode
on the camera, set the corresponding ISO
value also on the camera.
• Users can release the camera even if the
CFV is not ready for a capture. Make sure
the status LED on the CFV is green before
releasing the camera.
Start live view
1. Set B mode on the lens. If using an F type
lens, no special setting is required.
2. Use a lockable cable release and set it to
lock mode (B).
3. Activate Live View from Control Screen
(LV).
4. Release the camera with the cable
release.
5. Press the menu button or browse button
to end Live View.
6. Open the cable release lock.
Using CFV with 200 or 2000 Camera