58
X2D 100C
User Manual
CONTENTS
Moving and Adjusting Focus Point
Users can move the focus point and adjust the focus point size while shooting. Make sure
that Move AF Point is enabled before use. Follow the instructions below to set:
Go to Main Menu > Focus, scroll to the bottom, and then enable Move AF Point.
In Live View on the touch display, tap the display or swipe on the display to move the focus
point to the target position. Spread or pinch to zoom in or out on the focus point. If EVF is
used, the touch display can be used as a touchpad to move the focus point. Refer to the
Electronic Viewfinder (EVF) section for more information.
In Live View on the touch display or in EVF, press and hold the focus mode button, and the
focus point will change to a rectangle with arrows. In this mode, users can move the focus
point or adjust the focus point size.
• Toggle the front scroll wheel to move the focus point left and right and the rear scroll
wheel to move upward and downward.
• Press the circle button to the right of the touch display to adjust the focus point size to
large or small.
• Press the delete button to the right of the touch display to reset the focus point to the
centre of the screen.
After adjustment, press the focus mode button once to exit.
In Full Auto Exposure Mode, the focus point can only be moved using touch operations
on the touch display. Users cannot adjust the focus point size. It is also unable to move the
focus point by holding the focus mode button and using the scroll wheels.
To Next Page
Loading...
Need help?
General
