80
X2D 100C
User Manual
CONTENTS
Auto ISO Limits
Main Menu > Exposure > Auto ISO Limits
Set the maximum and minimum ISO values for when Auto ISO is set.
After configuration, when ISO is set to Auto in A, S, or P Exposure Mode, the ISO is set
automatically by the camera. It is unable to exceed these maximum and minimum limits.
Exposure Simulation
Main Menu > Exposure > Exposure Simulation
In Live View on the touch display or in EVF, the display will simulate the final image exposure.
Select A/S/P/Auto or A/S/P/Auto/M to enable the function in the corresponding exposure
mode.
• Exposure Simulation will not display a correct result when using the camera with a flash.
For example, when shooting with a flashlight indoors, normally, Exposure Simulation
displays an image that is too dark in Live View due to weak light conditions. It is
recommended to disable Exposure Simulation in Manual Exposure Mode before shooting
with a flash.
• When autofocus is enabled and is analysing the subject, Exposure Simulation is
deactivated to let the autofocus system operate in optimal conditions. When the
autofocus process is completed, Exposure Simulation is automatically activated again.
• When using Exposure Simulation with the exposure settings set to very high overexposure
or very low underexposure for the actual light conditions, Live View will display a very light
or very dark image. In extreme cases, it results in a completely overexposed white image
or a completely underexposed black image. In these cases, check the exposure scale
on the bottom left in Live View while adjusting the exposure settings to maintain desired
exposure.
To Next Page
Loading...
Need help?
General
