66
X2D 100C
User Manual
CONTENTS
2.11 ELECTRONIC VIEWFINDER (EVF)
Make sure that EVF-Rear Screen is selected to Auto or EVF Only in the Display settings in Main
Menu. EVF will be activated when approaching the EVF. Like the touch display, the EVF also
has Live View, Control Screen, Main Menu, and Browse Mode. Users can take photos, view the
camera status, set parameters, and browse files on different screens. Use the buttons on the
camera body to switch between screens rather than swiping on the touch display.
When using EVF, the touch display can be used as a touchpad. Gestures on the touchpad
are available to move the focus point and zoom in or out on the images.
Screen Display
The Live View display in EVF is the same display as the touch display. Press the circle button
on the camera body to switch between different information display.
Swipe on the area preset for the touchpad to move the focus point when Move AF Point is
enabled in the settings. See the following section.
The Control Screen display in EVF is the same as on the touch display. Set parameters using
the buttons and scroll wheels on the camera body rather than the touchpad.
The Browse Mode display in EVF is the same display as the touch display. Press the circle
button on the camera body to switch between different information on the display. Tap the
touchpad to show or hide the information displayed on the current image. The image rating
is disabled.
Dioptre Adjustment
The X2D 100C EVF supports electronic dioptre adjustment. Try adjusting the dioptre in the
settings when the EVF display is not clear. Refer to the Display Settings section for more
information.
Touchpad Operations
When using the touchpad in Live View, only operations in the preset area on the touchpad
will work. The descriptions below introduce touchpad area settings and operations in Live
View.
Setting Touchpad Area
The area depends on which eye is used when looking through the EVF. For example, if the
right eye is used, it is recommended to set it as Right. This will use the right half of the touch
display as a touchpad.
Follow the instructions below to set:
Go to Main Menu > General > Touch, and then select the touchpad area and sensitivity.
To Next Page
Loading...
Need help?
General
