61
X2D 100C
User Manual
CONTENTS
Interval
The camera will make a pre-determined number of exposures with a preset interval time.
Time: the time between exposures.
Frames: how many exposures will be made.
Initial Delay: a delay between shutter release and first exposure.
Metering: exposure metering for all frames or first frame only.
When Finished: determines if the function shall be active after a completed cycle or not.
Configure interval shooting parameters and press the shutter release button to start interval
shooting. If Initial Delay is set, the camera will start a countdown before shooting the first
image. Shooting will start after the preset delay ends.
The touch display, top display, and EVF will show information such as interval time
countdown and shot frames/total frames during the sequence. Press the delete button to
exit interval shooting if it is required to exit before completion.
200
5.6 90
f/
EV
+1.512.0
+0.7
CFe
SSD
ISO
Drive Mode Interval
Single
Continuous
Self Timer
Exposure
Bracketing
Interval
When Finished
Exit
Time
6s
Metering
Each Frame
Initial Delay
None
Frames
10
• Live View is disabled after interval shooting starts. If Preview is enabled in the Display
settings, users can preview the previously shot image while shooting. The interval
shooting information will display over the preview screen.
• When the interval time is set to 25s or more or the shutter speed is set to 16s or more,
the camera will turn off the display to save battery 5 seconds after the shooting starts. The
display will light up automatically before the next image is shot. Users can also wake up
the display by pressing the ON/OFF button.
• Interval shooting on the camera is disabled when the camera is connected to the Phocus
software on the computer or the Phocus Mobile 2 app on a mobile device. In this case,
use the capture sequencer in Phocus to achieve interval shooting.
To Next Page
Loading...
Need help?
General
