36
Enable or disable the access point’s 2.4GHz wireless radio.
When disabled, no 2.4GHz SSIDs will be active.
Select the wireless standard used for the access point.
Combinations of 802.11b, 802.11g & 802.11n can be
selected.
Select how many SSIDs to enable for the 2.4GHz frequency
from the drop down menu. A maximum of 16 can be
enabled.
Enter the SSID name for the specified SSID (up to 16). The
SSID can consist of any combination of up to 32 alphanumeric
characters.
Specify a VLAN ID for each SSID.
Enable/disable auto channel selection. Auto channel
selection will automatically set the wireless channel for the
access point’s 2.4GHz frequency based on availability and
potential interference. When disabled, select a channel
manually as shown in the next table.
Select a range from which the auto channel setting (above)
will choose a channel.
Specify a frequency for how often the auto channel setting
will check/reassign the wireless channel. Check/uncheck the
“Change channel even if clients are connected” box according
to your preference.
Set the channel bandwidth: 20MHz (lower performance but
less interference), 40MHz (higher performance but
potentially higher interference) or Auto (automatically select
based on interference level).
Set a Basic Service Set (BSS) rate: this is a series of rates to
control communication frames for wireless clients.
When auto channel is disabled, select a wireless channel manually:
To Next Page
Loading...
Need help?
General
