hecht 5196 - Fueling and Engine Oil Management; Motor Oil Requirements; Checking and Adding Engine Oil

36 / 68
PL
SK
DE
EN
CS
HU
CAUTION! A
Never refill the petrol in a room.
• Don’t smoke or use an open flame during refilling.
• Make sure you are away from heat, sparks and flames.
• If petrol is spilled, don’t start the engine. Immediately clean up the spilled petrol. Move
the machine from the area, where the petrol has been spilled and wait until the fuel vapours
dissipate to avoid the possibility of fire.
• Don’t use petrol containing ethanol.
• For engine protection, we recommend using a fuel stabiliser, which is available at filling stations.
• Make sure that water and dirt doesn’t get into the fuel tank.
• Fuel must not be older than 14 days.
Note: I Fuel can damage paint and some types of plastics. When topping up the fuel tank,
be careful and try not spill any petrol. Damage due to spillage of petrol is considered to be
due to improper use.
MOTOR OIL
CAUTION! A
This engine is delivered without oil, be sure to put oil in the engine before the starting.
Top-up the recommended oil type before first use.
Improper refilling or low oil levels can lead to irreparable engine damage.
• Only use the recommended types of engine oils with the appropriate performance
class. (The recommended oil type is given in the Specifications)
CHECKING THE OIL LEVEL AND ADDING
C Check the oil level only when the engine is off and cool. The machine must stand level.
1. Remove the filler plug with the attached dipstick (fig. 18A) and clean the oil from the dipstick.
2. Insert the dipstick plug as far as it will go into the oil filler neck, but do not screw it on. Then
remove it again. After removing it, this time read the oil level on the dipstick.
3. If there is a trace of the oil level on the dipstick near or below the minimum limit line, top-
up the engine oil so that the oil level is between the maximum and minimum lines (fig. 19).
- Do not mix different oils. When topping-up, always use the exact same oil as that
currently in the engine.
- Do not overfill. In case of overfilling, drain off any excess oil.
4. Refit and tighten the filler plug with the attached dipstick.
Change the oils according to the paragraph of MAINTENANCE / OIL CHANGE.
OIL LEVEL SENSOR
- serves to prevent engine damage when there is insufficient oil in the crankcase. When
the oil level drops below a safe level, the engine stops and/or does not start.
- never unplug!