50 / 68
PL
SK
DE
EN
CS
HU
CAUTION! A
While charging the battery releases explosive and toxic fumes. Charge the battery
in a well-ventilated place. DO NOT SMOKE AND KEEP AWAY FROM OPEN FLAMES
AND SPARKS.
Never charge the battery in an explosive or flammable environment or near
flammable liquids, and don‘t charge on a slightly flammable substrate (such as
paper, textiles, etc.).
Never charge a battery which is visibly damaged or its filling is leaking.
TIRE PRESSURE
Regularly check tire pressure keep it at the specified values (see Specifications).
REPLACING WHEELS
Stop the machine on flat ground and put a block under a load-bearing part of the frame on
the side that the wheel is to be changed. The wheels are held by a snap ring which can be eased
off with a screwdriver (fig. 40-41).
Note: I
If you need to replace the wheels, new wheels must be the same diameter.
C Before remounting the wheel, apply grease to the axle. Put the snap ring and
supporting washer back in place.
REPLACING A FUSE
(fig. 42-43)
The machine is fitted with fuse. When it blows, the machine stops, the dashboard light switches off
and the battery gradually runs out, the machine will have problems starting.
A blown fuse must always be replaced by one of the same type and rating, and never with one of
another rating. If you cannot find eliminate the causes of the tripping, consult an authorized service.
A fuse can be found in the connector on the wiring mounted behind fuel tank.
DISMANTLING, REPLACING AND REMOUNTING THE BLADES
CAUTION! A
Always wear work gloves when handling blades. Before inspecting or removing
the blades, switch the engine off and secure it against the possibility of accidental
starting.
Damaged or bent blades must always be replaced with identical blades or blades
recommended by the manufacturer. The blades are not identical and rotate in
the opposite direction! Therefore, when assembling, make sure they are installed
correctly and in the correct position (as indicated by the symbol on the outside of
each blade).
C The blades must be balanced properly.
To Next Page
Loading...
