38 / 68
PL
SK
DE
EN
CS
HU
- the operator must be sat in their position
- the parking brake must be activated
- properly assembled and secured collection basket
- to have a sufficient amount of engine oil
B. The engine shuts off when:
- the operator leaves their seat and the blades are engaged
- the operator leaves their seat and the gearbox isn‘t in „neutral“ position
- the operator leaves their seat if the gearbox is in „neutral“ position but the parking
brake isn‘t engaged,
- the collection basket is pulled out or the protective trim is removed when the blades
are engaged
DIRECTIONS BEFORE STARTING WORK
Before starting to mow, it is necessary to carry out several checks and operations to ensure you
can work efficiently and in maximum safety.
SEAT ADJUSTMENT
To change the seat position, loosen the four fixing bolts and slide it along the slots (fig. 8). Once
you have found the right position, tighten the four screws.
CHARGE PRESSURE FOR TIRES (fig. 20-21)
Make sure there is the right tire inflation pressure (see Specifications). If the pressure is too low,
the hose may slip down on the casing and get damaged. Excessive over inflation can lead to
a tire explosion.
To inflate the tires use an inflation gun featuring pressure gauge.
• The tyre inflation pressure values are given in the Specifications at the beginning
of the manual.
CHECKING THE FUEL AND OIL
Check oil and fuel in the tank.
CHECK THAT THE BRAKE IS IN PERFECT WORKING ORDER.
Do not start mowing if the blades vibrate or if you are unsure whether they are sharp
enough. Always remember that:
- A badly sharpened blade pulls at the grass and causes the lawn to turn yellow.
- A loose blade causes unwanted vibrations and can be dangerous.
CAUTION! A
Do not use the machine if you are unsure whether it is working safely or efficiently. If
in doubt, contact your Dealer immediately to make the necessary checks and repairs.
To Next Page
Loading...
