hecht 5196 - Clean Air Cooling System; Storage

52 / 68
PL
SK
DE
EN
CS
HU
• Clean the plastic parts of the body with a damp sponge using water and detergent, taking
care not to wet the engine, the electrical parts or the electronic circuit board located under
the dashboard.
C Never use hose nozzles or harsh detergents to clean the body work or the engine!
When washing the inside of the cutting deck and the collector channel, the machine must be
on firm ground with:
- the grass-catcher or stone-guard fitted;
- the operator seated;
- the engine running;
- the transmission in neutral;
- the blades engaged.
Connect a water hose to each of the pipe fittings (fig. 46) - if equipped - one at a time and run
water through each one for a few minutes, with the blades moving.
When washing, the cutting deck should be lowered right down. Take off the grasscatcher,
empty and rinse it, and then put it in a position where i
CLEAN AIR COOLING SYSTEM
• Allow muffler, engine cylinder and fins to cool before touching.
• Remove accumulated debris from muffler area and cylinder area.
C The engine is air-cooled. Dirt can reduce airflow and cause the engine to overheat,
which reduces engine performance and life.
Use a dry brush or cloth to remove dirt from the finger guard/rotating curtain. Keep the draw
bars, springs and controls clean. Remove flammable dirt from the surroundings of the exhaust
silencer.
After a period of time, debris can accumulate in the cylinder cooling fins and cause the engine
to overheat. This debris cannot be removed without partial disassembly of the engine. Have
a Authorized Service Dealer inspect and clean the air cooling system as recommended in
the Maintenance Schedule.
• After washing and cleaning, repair the damaged paint and apply a thin layer of oil
to areas that may rust.
STORAGE
CLEAN THE MACHINE BEFORE STORING ACCORDING TO THE PARAGRAPH
MAINTENANCE / CLEANING.
CAUTION! A
Store this machine on place where the fuel vapors can not be in reach of open fire or
sparks. Let the fuel to run dry before long storage. Always let the machine get cool
before storing.