Technical Data and Accessories
7–6 Edition September 2000
ABC
Power connection
Power connection is performed via a supplied
power connection cable. The electrical outlet is
located on the lower rear of the device
underneath the service flap.
All electrical components have automatic cutouts.
If one of these fuses reacts, this indicates a major
technical defect which can only be eliminated by
Service personnel.
Power cables must be connected in accordance
with the regulations of the respective country.
Fuses
The operator has no access to the device fuse! The
device may only be serviced by Service personnel.
The in-house electrical outlet to which the power
cable is connected must be fused with a maximum
value of 10 A.
Light Conditions
Operational conditions: no fluorescent lighting
no direct sunlight
Device Emissions
Heat emission approx. 150 W
Noise emission < 55 dB (A)
(value measured at operator desk)
To Next Page
Loading...
Need help?
General
