Service and Maintenance
6–20 Edition September 2000
ABC
0
Wipe off the ethanol
Moisten a lint-free cloth with a small
amount of ethanol and remove the liquid
by wiping the cloth in the same direction
applying a little bit of pressure.
A thin film of alcohol (which will
evaporate) should be left on the surface.
Note: Cleaning is successful if
the film of alcohol does not
form any drops and evaporates
without leaving any streaks.
Repeat the procedure if
necessary!
If you also wish to clean the other side of
the original, lift the original and wipe the
glass plate dry. Then clean as described
above.
(Subsequently clean off the dust)
Dust
Carefully pull the original through the antistatic
device.
Remove dust from the original using a grounded
antistatic brush and oil-free compressed air.
Note: Do not blow the compressed air over the
original in short blasts as this would cause
condensation. Use a steady stream of air over the
original!
2
2
To Next Page
Loading...
Need help?
General
