HEIDELBERG Nexscan F 4100 User Manual

Service and Maintenance
6–2 Edition September 2000
ABC
Fluorescent Lamps
Attention: To ensure that the fluorescent lamps
function properly, the lamps are only switched
OFF when the scanning mode is changed
(reflective/transparent) or when no scanning has
taken place for a longer period of time.
If the lamps for scanning are no longer able to
illuminate sufficiently or are defective, the
corresponding fluorescent lamp must be replaced.
It is imperative that you only use clean fluorescent
lamps. If necessary, clean the lamp before
installation. Finger prints should likewise be
avoided as the grease can reduce the length of
operation.
11 watt fluorescent lamps are used for
the illumination of reflection or
transparent originals in the Nexscan
F 4100/F 4200.
The 11 watt fluorescent lamp is likewise
used for the illumination of originals in
the scanner.
Lamp used:
Osram FM 11W/860 Lumilux Tageslicht
1

HEIDELBERG Nexscan F 4100 Specifications

General

Brand	HEIDELBERG
Model	Nexscan F 4100
Category	Scanner
Language	English