HEIDELBERG Nexscan F 4100 User Manual

Connecting
2–2 Edition September 2000
ABC
The Nexscan F 4100/F 4200 has an SCSI
connection. You should always fit an SCSI
interface card to your computer, to which only
the scanner is connected. Commands which are
sent from the workstation to the Nexscan F 4100/
F 4200 and image data which is transferred from
the Nexscan F 4100/F 4200 to the workstation
pass through this link. The Nexscan F 4100/
F 4200 can be connected to any other SCSI device,
which has an SCSI connection, by means of the
connection cable – observe the length of the
cable when setting up the system.
Connect the SCSI cable for the Nexscan F 4100/
F 4200 to the SCSI port of your computer.
If, in addition to the Nexscan F 4100/F 4200 and
the operating unit, other SCSI devices are
connected to the SCSI bus, the Nexscan F 4100/
F 4200 must always be the last link in the chain,
as the SCSI bus in the Nexscan F 4100/F 4200 has
a terminator.
The SCSI bus must not exceed a total length of
6 m, otherwise you may encounter operational
difficulties.
Observe the length
of the SCSI cable!

HEIDELBERG Nexscan F 4100 Specifications

General

Brand	HEIDELBERG
Model	Nexscan F 4100
Category	Scanner
Language	English