Fundamentals | Control model, software and features
16
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Modified functions 81760x-01
Up to 4 M functions are now allowed in an NC block, see
"Fundamentals", page 468
New soft keys for transferring values have been introduced in
the pocket calculator, see "Operation", page 207
The distance-to-go display can now also be displayed in the
input system, see "Select the position display", page 747
Several input parameters have been added to
Cycle 241 SINGLE-LIP DEEP HOLE DRILLING,
see Cycle Programming User's Manual
Parameter Q305 NUMBER IN TABLE has been added to Cycle
404, see Cycle Programming User's Manual
In the thread milling cycles 26x an approaching feed rate has
been introduced, see Cycle Programming User's Manual
In Cycle 205 Universal Pecking you can now use
parameter Q208 to define a feed rate for retraction,
see Cycle Programming User's Manual
To Next Page
Loading...
