HEIDENHAIN TNC 620 - Resetting Dwell Time

Special Functions | Dwell time FUNCTION FEED
12
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
527
Resetting dwell time
Reset to the dwell time immediately following the
machining with chip breaking.
Example
18 FUNCTION FEED DWELL RESET
Use FUNCTION FEED DWELL RESET to reset the recurring dwell
time.
Proceed as follows for the definition:
Show the soft-key row with special functions
Press the PROGRAM FUNCTIONS soft key
Press the FUNCTION FEED soft key
Press the RESET FEED DWELL soft key
You can also reset the dwell time by entering D-TIME 0.
The control automatically resets the FUNCTION FEED
DWELL function at the end of a program.