HEIDENHAIN TNC 620 - Page 193

Fundamentals, File Management | Working with the file manager
4
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
193
ITC touchscreen configuration
Using the additional ITC Touchscreen Configuration tool, you can
select the touch sensitivity of the touch screen.
The ITC gives you the following options:
Normal Sensitivity (Cfg 0)
High Sensitivity (Cfg 1)
Low Sensitivity (Cfg 2)
Use the Normal Sensitivity (Cfg 0) setting as standard. If you find
it difficult to operate the equipment while wearing gloves in this
setting, select the High Sensitivity (Cfg 1) setting.
If the ITC touch screen is not splash-proof, select the
Low Sensitivity (Cfg 2) setting. This stops the ITC
interpreting drops of water as touches.
Configuration involves the following steps:
Start the tool in control using the task bar
The ITC opens a pop-up window with three options
Select Touch Sensitivity
Press the OK button
The ITC closes the pop-up window