HEIDENHAIN TNC 620 - Page 417

Programming Q Parameters | Additional functions
10
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
417
Group
name
Gruppen-
nummerID
Systemdaten-
nummer
Index Description
20 - Information on combined milling/turning
mode of operation:
0 = Milling (after FUNCTION MODE MILL)
1 = Turning (after FUNCTION MODE TURN)
10 = Execute the operations for the turning-
to-milling transition
11 = Execute the operations for the milling-to-
turning transition
30 - Interpolation of multiple axes permitted?
0 = No (e.g. for straight cut control)
1 = yes
31 -
R+/R– possible/permitted in MDI mode?
0 = No
1 = Yes
0 Cycle call possible/permitted?
0 = No
1 = Yes
32
Cycle number Single cycle enabled:
0 = No
1 = Yes
40 -
Copy tables in Test Run operating mode?
Value 1 will be set when a program is select-
ed and when the RESET+START soft key is
pressed. The iniprog.h system cycle will
then copy the tables and reset the system
datum.
0 = no
1 = yes
101 - M101 active (visible condition)?
0 = no
1 = yes
136 - M136 active?
0 = no
1 = yes