HEIDENHAIN TNC 620 - Page 42

Contents
42
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
6 Tools............................................................................................................................................... 229
6.1 Entering tool-related data................................................................................................................. 230
Feed rate F...........................................................................................................................................230
Spindle speed S................................................................................................................................... 231
6.2 Tool data..............................................................................................................................................232
Requirements for tool compensation.................................................................................................. 232
Tool number, tool name....................................................................................................................... 232
Tool length L........................................................................................................................................ 232
Tool radius R........................................................................................................................................ 232
Delta values for lengths and radii........................................................................................................233
Entering tool data into the NC program.............................................................................................. 233
Entering tool data into the table..........................................................................................................234
Importing tool tables............................................................................................................................243
Overwriting tool data from an external PC..........................................................................................245
Pocket table for tool changer...............................................................................................................246
Calling the tool data.............................................................................................................................249
Tool change.......................................................................................................................................... 251
Tool usage test.....................................................................................................................................254
6.3 Tool compensation.............................................................................................................................256
Introduction.......................................................................................................................................... 256
Tool length compensation....................................................................................................................256
Tool radius compensation.................................................................................................................... 257
6.4 Tool management (option number 93)............................................................................................260
Basics................................................................................................................................................... 260
Calling tool management..................................................................................................................... 261
Editing tool management.....................................................................................................................262
Available tool types..............................................................................................................................266
Importing and exporting tool data....................................................................................................... 268