HEIDENHAIN TNC 620 - Page 51

Contents
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
51
Editing text blocks................................................................................................................................516
Finding text sections............................................................................................................................517
12.9 Freely definable tables...................................................................................................................... 518
Fundamentals....................................................................................................................................... 518
Creating a freely definable table..........................................................................................................518
Editing the table format.......................................................................................................................519
Switching between table and form view.............................................................................................520
FN 26: TABOPEN – Open a freely definable table..............................................................................521
FN 27: TABWRITE – Write to a freely definable table.........................................................................522
FN 28: TABREAD – Read from a freely definable table...................................................................... 523
Customizing the table format.............................................................................................................. 523
12.10 Pulsing spindle speed FUNCTION S-PULSE....................................................................................524
Programming a pulsing spindle speed.................................................................................................524
Resetting the pulsing spindle speed................................................................................................... 525
12.11 Dwell time FUNCTION FEED............................................................................................................ 526
Programming dwell time......................................................................................................................526
Resetting dwell time............................................................................................................................527
12.12 Dwell time FUNCTION DWELL......................................................................................................... 528
Programming dwell time......................................................................................................................528
12.13 Lift off tool at NC stop: FUNCTION LIFTOFF.................................................................................. 529
Programming tool lift-off with FUNCTION LIFTOFF............................................................................ 529
Resetting the lift-off function............................................................................................................... 531