HEIDENHAIN TNC 620 - Page 53

Contents
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
53
Definition of a normalized vector.........................................................................................................581
Permissible tool shapes....................................................................................................................... 582
Using other tools: Delta values........................................................................................................... 582
3-D compensation without TCPM....................................................................................................... 583
Face Milling: 3D compensation with TCPM........................................................................................584
Peripheral milling: 3-D radius compensation with TCPM and radius compensation (RL/RR)............... 586
Interpretation of the programmed path...............................................................................................588
13.7 Running CAM programs....................................................................................................................589
From 3-D model to NC program..........................................................................................................589
Consider with post processor configuration........................................................................................590
Please note the following for CAM programming...............................................................................592
Possibilities for intervention on the control......................................................................................... 594
ADP motion control............................................................................................................................. 595