HEIDENHAIN TNC 620 - Page 62

Contents
62
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
20 Tables and Overviews..................................................................................................................775
20.1 Machine-specific user parameters....................................................................................................776
Application............................................................................................................................................776
20.2 Connector pin layout and connection cables for data interfaces..................................................790
RS-232-C/V.24 interface for HEIDENHAIN devices..............................................................................790
Non-HEIDENHAIN devices...................................................................................................................792
Ethernet interface RJ45 socket........................................................................................................... 792
20.3 Technical Information.........................................................................................................................793
User functions......................................................................................................................................795
Software options.................................................................................................................................. 798
Accessories.......................................................................................................................................... 801
20.4 Overview tables................................................................................................................................. 802
Fixed cycles..........................................................................................................................................802
Miscellaneous functions...................................................................................................................... 804
20.5 Functions of the TNC 620 and the iTNC 530 compared................................................................ 806
Comparison: Specifications..................................................................................................................806
Comparison: Data interfaces................................................................................................................806
Comparison: PC software.................................................................................................................... 807
Comparison: User functions................................................................................................................ 807
Comparison: Miscellaneous functions................................................................................................. 815
Comparator: Cycles..............................................................................................................................817
Comparison: Touch probe cycles in the Manual operation and Electronic handwheel modes of
operation...............................................................................................................................................819
Comparison: Probing system cycles for automatic workpiece control................................................820
Comparison: Differences in programming........................................................................................... 822
Comparison: Differences in Test Run, functionality.............................................................................825
Comparison: Differences in Test Run, operation................................................................................. 826
Comparison: Differences in Manual Operation, functionality.............................................................. 827
Comparison: Differences in Manual Operation, operation...................................................................828
Comparison: Differences in Program Run, operation.......................................................................... 828
Comparison: Differences in Program Run, traverse movements.........................................................829
Comparison: Differences in MDI operation......................................................................................... 834
Comparison: Differences in programming station............................................................................... 834