HEIDENHAIN TNC 620 - Page 648

Manual Operation and Setup | Managing presets
16
648
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Editing the preset table
Soft key Editing function in table mode
Select the table start
Select the table end
Select the previous page in the table
Select the next page in the table
Select the functions for entry of presets
Choose between showing the Basic Transforma-
tion or the Axis Offset
Activate the preset of the selected row of the
preset table
Add multiple rows to the end of the table (2nd soft-
key row)
Copy the highlighted field (2nd soft-key row)
Insert the copied field (2nd soft-key row)
Reset the selected row: The control enters – in all
columns (2nd soft-key row)
Insert a single line at the end of the table (2nd soft-
key row)
Delete a single line at the end of the table (2nd
soft-key row)