HEIDENHAIN TNC 620 - Page 778

Tables and Overviews | Machine-specific user parameters
20
778
HEIDENHAIN | TNC 620 | Conversational Programming User's Manual | 10/2017
Parameter list
Parameter settings
DisplaySettings
Settings for screen display
Sequence of displayed axes
[0] to [7]
Depends on available axes
Sequence of the displayed axes in the REF display
[0] to [7]
Depends on available axes
Type of position display in position window
NOMINAL
ACTUAL
REF ACTL
REF NOML
LAG
ACTDST
REFDST
M 118
Type of position display in status display
NOMINAL
ACTUAL
REF ACTL
REF NOML
LAG
ACTDST
REFDST
M 118
Definition of decimal separator for position display
. point
, comma
Display of feed rate in operating mode Manual operation
at axis key: Only display feed rate if axis direction key is pressed
always minimum: Always display feed rate
Display of spindle position in the position display
during closed loop: Only display spindle position if spindle is in position control
during closed loop and M5: Display spindle position if spindle is in position control
and with M5
Show or hide soft key preset table
True: Soft key preset table is not displayed