HEKA EPC 9 - Page 88

Controlling E9Screen EPC9 Installation 88
GetCFastError
GetCFastTau
GetClipping
GetCSlow
GetCSlowError
GetCSlowRange
GetCurrentGain get gain in Ohms (i.e., V/A)
GetE9SBoard
GetE9SerialNo
GetF2Butterworth
GetF2Frequency
GetFilter1
GetGLeak
GetGSeries
GetIpipette
GetLastVHold
GetMode
GetRmembrane
GetRsFraction
GetRsMode
GetRsValue
GetStimFilterOn
GetVCStimScale
GetVersion
GetVHold
GetVLiquidJunction
GetVmonitor
GetVpOffset
“Set” operations: They have no or one parameter and do not return a response.
SetAdcChannel integer: 0 to 12 -> FExt, Vmon, Imon1, Imon2,
none, ADC0 .. ADC7
SetCCFastSpeed boolean: 0 or 1
SetCCIHold real: current in Amperes
SetCCRange boolean: 0 or 1
SetCFast2 real: capacitance in Farad
SetCFastTau real: tau in seconds
SetCSlow real: capacitance in Farad
SetCSlowRange integer: 0,1,2,3 -> off,30,100,1000pF range
SetCurrentGain set gain in Ohms (i.e., V/A)
SetE9Board integer: 1,2,3
SetF2Frequency real: bandwidth in Hertz
SetF2Butterworth boolean: 0 or 1
SetFilter1 integer: 0,1,2,3 -> 100,30,10kHz,HQ30kHz
SetGLeak real: in Siemens (i.e., 1/Ohms)
SetGSeries real: in Siemens (i.e., 1/Ohms)
SetLastVHold no parameters
SetMode 0 to 3, corresponding to Test, VC, and CC.
SetRsFraction real: 0.0 to 0.95
SetRsMode integer: 0,1,2,3 -> off,100,10,2 µs
SetRsValue real: in Ohms
SetStimFilterOn boolean: 0 or 1
SetStimScale real: -10.0 to +10.0 (0.0 means off)
SetTestPulse boolean: 0 or 1
SetVHold real: -1.0 to +1.0 Volt
SetVLiquidJunction real: -1.0 to +1.0 Volt minus VHold
SetVpOffset real: -0.2 to +0.2 Volt
Miscellaneous Operations