034-11592_1.0_19.11.2018
103
Operation
The ambient temperature during the charging process
must be within the range from 0 °C to 40 °C.
The battery can remain on the bicycle or be removed
for charging.
Interrupting the charging process does not damage
the battery.
On a bicycle which is equipped with two batteries, the
charging process for both batteries is started from the
pannier rack battery.
Remove the rubber cover from the battery.
Connect the mains plug of the charger to a normal
domestic, grounded socket.
Connect the charging cable to the battery's
charging port.
The charging process starts automatically.
During the charging process the operating and
charge status indicator indicates the charge status.
When the drive system is switched on, the display
shows the charging process.
Disconnect the battery from the charger and allow it to
cool down. Do not connect the rechargeable battery to
the charger again until the permitted charging
temperature has been reached.
The charging process is complete when the LEDs
of the operating and charge status indicator go out.
Once charging is complete, disconnect the battery
from the charger and the charger from the mains.
Connection data
230 V, 50 Hz
If the battery is outside its
charging temperature range,
three LEDs will flash on the
charge level indicator.
EN_034-11592_1.0_0.01_19.08.2018_HERCULES BOSCH Purion MY19_Inhalt.book Seite 103 Montag, 19. November 2018 11:00 11
To Next Page
Loading...