034-11592_1.0_19.11.2018
81
Before the first ride
6.2.2.1 Checking the clamping force of the quick releases
Open and close the quick releases on the stem or
the seat post.
The clamping force is sufficient if the clamping
lever can be moved easily from the open final
position into the middle and has to be pressed with
the fingers or base of the thumb from the middle
point onwards.
6.2.2.2 Adjusting the quick release clamping force
If the clamping lever on the handlebars cannot be
moved into its final position, screw out the knurled
nut.
Tighten the knurled nut on the seat post if the
clamping lever's clamping force is not sufficient.
6.3 Adjusting the brake lever
6.3.1 Adjusting the pressure point on a Magura brake
lever
WARNING
!
Brake failure due to incorrect setting
If the pressure point is set with brakes where the brake
lining and brake disc have reached their wear limit, the
brakes may fail and cause an accident with injury.
The pressure point setting is adjusted using the twist
knob.
Turn the twist knob towards the plus (+) symbol.
If you are unable to set the clamping force, the
specialist dealer will need to check the quick release.
Before you set the pressure point, ensure that the
brake lining and brake disc have not reached their
wear limit.
EN_034-11592_1.0_0.01_19.08.2018_HERCULES BOSCH Purion MY19_Inhalt.book Seite 81 Montag, 19. November 2018 11:00 11
To Next Page
Loading...