Before the first ride
034-11592_1.0_19.11.2018
78
6.2 Setting the handlebars
Table 23: Handlebars clamping screw maximum tightening torque
Maximum tightening torque for the
clamping screws of the handlebars*
*if there is no other data on the component
5 Nm - 7 Nm
Adjusting the stem
CAUTION
!
Crash caused by loose stem
Incorrectly fastened screws may come loose due to
impact. The stem may no longer be firmly fixed in its
position as a result. This will result in a crash and
injuries.
The handlebars must only be adjusted while the
bicycle is stationary.
Unfasten and adjust the designated screw
connections, and clamp them with the maximum
tightening torque for the clamping screws of the
handlebars.
Check the handlebars and the quick release system
are firmly in position after the first two hours of
riding.
EN_034-11592_1.0_0.01_19.08.2018_HERCULES BOSCH Purion MY19_Inhalt.book Seite 78 Montag, 19. November 2018 11:00 11
To Next Page
Loading...