20
PRE-RIDE INSPECTION
You should conduct pre-ride inspection
before riding the motorcycle to enhance riding
comfort and safety.
Clean your motorcycle regularly. It protects
the surface finish. Avoid cleaning with
products that are not specifically designed for
motorcycle surfaces.
Inspect your motorcycle every day before you
start the engine. The items listed here will only
take few minutes, and in the long run they can
save time, expense, and possibly your life.
Please follow the tips as given below:
î Engine oil level-Check and top up engine
oil if required (page 29). Check for leaks.
î Fuel level-Ensure sufficient fuel is
available in your fuel tank for your journey
(page 18). Check for leaks.
î Front brake (Disc type)-Check for
correct brake fluid level in the master
cylinder (pages 39).
î Front and (Drum type)Rear brake -
Check operation. Adjust free play if
necessary (pages 40-42).
î Tyres-Check condition and pressure
(page 30-33).
î Clutch-Check for smooth operation.
Adjust free play (page 39 & 40).
î Drive chain-Check condition and
slackness (page 39). Adjust and 37-
lubricate if necessary.
î Throttle-Check for smooth opening and
closing in all steering positions (page 34).
î Lamp and horn-Check that headlamp,
tail/stop lamp, turn signal lamps, indicators
and horn function properly.
î Rear view mirror-Ensure that the rear
view mirror gives a good rear view when
you are sitting on the motorcycle.
î i3s Switch-Make sure whether the i3s
switch is in “ON” or “OFF” position
(page 15).
î i3s System-Make sure that i3s system is
functional properly (page 15).
î Fitting & fasteners-Check & tighten if
necessary.
î Steering-Check for smooth action for
easy maneuverability.
î Air suction valve-Make sure all tube
connections are secured properly
(page 53).
î Side stand indicator-Make sure the side
stand is up. If it is in down position the side
stand indicator (page 17) will glow on
speedometer panel.
To Next Page
Loading...
