î Fill the crankcase through the filler hole
with approximately 1.1 litres of the
recommended grade oil (When right
crankcase cover is not removed).
î Reinstall the oil level dipstick with a new
O-ring.
î Start the engine and allow it to idle for few
minutes.
î Stop the engine and let the engine oil settle
down.
î Recheck the oil level.
î Make sure that oil level is at the “UPPER”
level mark of the oil level dipstick with the
motorcycle in an upright position and that
there are no oil leaks.
30
CAUTION
!!
î Running the engine with insufficient oil can
cause serious engine damage.
î Running the engine with excessive oil can
cause spark plug fouling & loss in
performance.
î Engine oil is a major factor affecting the
performance and service life of the engine.
Non-detergent, vegetable or castor based
racing oils are not recommended.
OIL FILTER SCREEN & CENTRIFUGAL
FILTER
î Drain the engine oil throughly.
î Remove the rider foot rest (1), kick starter
pedal (2), muffler disconnect the clutch
cable (3). Remove the right crankcase
cover (4).
î Remove gasket and dowel pin.
î Remove the oil filter screen (5) and wash it
in clean non flammable or high flash point
solvent (kerosene).
î Reinstall the oil filter screen with tapered
end facing in.
1
2
3
4
(1) Rider foot rest (2) Kick starter pedal
(3) Clutch cable (4) Right crankcase cover
5
6
(5) Oil filter screen (6) Centrifugal filter cover
(7) Centrifugal filter
7
To Next Page
Loading...
