29
•
The i3s indicator (2) will glow on the
speedometer console for 2 seconds and
turn “OFF”.
(1) i3s switch
1
(2) i3s indicator
2
• Start the engine and let it idle for 2-3
minutes.
NOTE
•
The engine will stall if the i3s switch is in
“ON” position during warm up.
•
Use choke during cold conditions.
NOTE
• In this condition, the engine can be restarted
either with brake & slight throttle, brake
& electric start or kick.
Initial activation of the i3s system:
• Turn the ignition key to “ON” ( ) position.
• Keep the i3s switch (1) to “ON” position.
• The engine will turn off in 30±1 secs. After
the first stop start, every subsequent stop will
be in 5±1 secs.
• The i3s indicator (2) on the speedometer
console will glow for 2 seconds and turns
“OFF”.
• Start the engine and allow it to run at idle
r/min.
• Put the vehicle in stand still condition on its
main stand (Speedometer pointer is on 0
Km/h).
Ensure that the r/min should not cross
2000.
•
If for the first time vehicle is started and rider
crosses 11km/h speed. After that, vehicle is
kept in idle (Speedometer pointer is on 0
Km/h) then the engine will be turned “OFF”
in 5±1 seconds.
•
To re-start the vehicle with i3s switch in
“ON” position, apply brake & slight throttle.
Vehicle will not start with sudden throttle.
Driving with i3s switch in “ON” position:
If the engine is stopped by i3s and its remain
in “OFF” condition for more than 500 secs
then vehicle can only be started with brake &
electric starter switch or kick.
To Next Page
Loading...
