HERO MAESTRO EDGE 2021 - Final Drive Oil Replacement

(3) Spring (4) Oil strainer screen (5) O-ring
70
4
3
5
CAUTION
!!
•
Engine oil quality is the chief factor affecting
engine service life. Replace and top-up the
engine oil as specified in the maintenance
schedule (page 61).
•
When running in very dusty conditions, oil
changes should be performed more
frequently than specified in the maintenance
schedule.
•
Please dispose used engine oil in a manner
that is compatible with the environment. We
suggest you take it in a sealed container to
your local recycling center or service station
for reclamation. Do not throw it in the trash
or pour it on the ground or down a drain.
•
Used engine oil may cause skin disease if
repeatedly left in contact with the skin for
prolonged periods. Although this is unlikely
unless you handle used oil on a daily basis,
it is still advisable to thoroughly wash your
hands with soap and water as soon as
possible after handling used oil.
WARNING
!!
•
The spring (3) and oil strainer screen (4)
will come out when the oil strainer screen
cap is removed.
•
Check that the oil strainer screen, sealing
rubber and cap O-ring (5) are in good
condition.
•
Clean the oil strainer screen.
At engine disassembly: 0.80 litre
•
Switch “OFF” the i3s switch.
•
Fill crankcase with the recommended grade
of oil:
•
Install the oil level dipstick.
At draining: 0.70 litre
•
Start the engine and let it idle for 2-3
minutes. Stop the engine and ensure that
the oil level is at the upper level mark on the
oil level dipstick with the vehicle upright on
flat level surface. Ensure there are no oil
leaks.
•
Install the oil strainer screen, spring and oil
strainer screen cap with new O-ring. Install
the drain plug.
The final drive oil should be replaced as per
the maintenance schedule. Replacement
requires mechanical skill. It is suggested to get
it replaced by Authorised Distributor/Dealer.
•
Park the vehicle on its main stand.
•
Stop the engine and wait for 2-3 minutes.
FINAL DRIVE OIL REPLACEMENT
GRADE : SAE 10W 30 SL Grade
•
Switch “OFF” the i3s switch.
•
Start the engine and let it idle for 3-5
minutes.