61
*Replace at any point of time, if pre foam and viscous element found damaged.
E: EMISSION CHECK
The following maintenance schedule specifies all maintenance required to keep your vehicle in peak operating
condition. Maintenance work should be performed in accordance with standards and specifications of Hero
MotoCorp by properly trained and equipped technicians. Your meets all of Authorised Distributor/Dealer
these requirements.
Note-5 : Replace once in every 12000 km.
Note-2 : Throttle play to be checked and adjusted as per given specification.
Note-3 : Replace air cleaner element once in every 15000 km or early replacement may be required
when riding in dusty areas.
Note-4 : Service more frequently when riding in rain or at full throttle.
I: INSPECT C: CLEAN R: REPLACE A: ADJUST L: LUBRICATE T: TOP UP
*At 12000 km inspect if air cleaner element (viscous type) is choked. If found choked, replace
the air cleaner element to keep the engine healthy.
Note-9 : Service more frequently if the vehicle is ridden in unusually wet or dusty areas.
MAINTENANCE SCHEDULE
Ensure that each paid service is availed within 90 days or 3000 km from the date of previous service,
whichever is earlier.
Note-10: Replace the pinion starter assembly once in every 2 years or 21000 km, whichever is earlier.
Note-8 : Clean carburetor if required after inspection during service.
Note-11: Replace drive belt once in every 24000 km.
To be serviced by your unless the owner has the relevant tools, Authorised Distributor/Dealer
technical information and is technically qualified.
Note-1 : At higher odometer readings, repeat the frequency interval established here.
Perform the pre-ride inspection (page 49) at each scheduled maintenance period.
In the interest of safety, we recommend that these jobs are carried out only by your Authorised
Distributor/Dealer.
Note-12: Replace the front fork oil once in every 2 years or 20000 km, whichever is earlier.
Note-13: Inspect for any play in the mounting bushes, replace if necessary.
Note-6 : Replace engine oil once in every 6000 km. Top up if the oil level is at or near the lower level
mark.
Note-14: Inspect the bearings free play, replace if necessary.
Note-7 : Replace once in every 10000 km or once in a year, whichever is earlier. Replacement requires
mechanical skill.
Note-15: Check idle CO emission along with idle r/min/idle CO adjustment (if required).
To Next Page
Loading...
