EasyManua.ls Logo

HERO PASSION PRO PROGRAMMED FI - Page 23

HERO PASSION PRO PROGRAMMED FI
76 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
19
and let it idle till engine temperature reaches
more than 75°C. The engine will cut-off in
30 seconds. After the first stop start, every
subsequent stop will be in 5 seconds.
In this condition, the engine can be restarted
either with clutch lever, kick or electric start.
While driving, if the engine is kept idling (while
waiting in a traf c signal), the engine will cut fi
off in 5 sec . (The vehicle should be inonds
stand still condition, with gear position neutral
at th n clutch less a 2000 r/min with
lever/throttle is in released position and
engine is warmed up The i3s indicator will ).
be continuously blinking in the meter
indicating that vehicle stopped in i3s
condition. By pressing the clutch lever, the
engine will start again and gear can be
engaged to move the vehicle.
Driving with i3s switch in “ON” position:
NOTE
If engine is stopped by any means other than
i3s function, i3s indicator will not glow/
blink in the meter. In this condition, vehicle
will not start by pressing the clutch lever.
Vehicle can be started by using kick or
electric start.
If vehicle stops in i3s condition and kept idle
for more than 500 secs (ignition switch is
“ON” position) i3s function will be deactivated
and cannot be started by pressing the clutch
lever, rider can only start the vehicle with
electric or kick start.
If all the required i3s conditions are met, i3s
indicator will glow for 5 secs before the
engine cuts-off.
Driving with i3s switch in “OFF” position:
While riding in a traffic jam/or very dense
traffic where the vehicle has to encounter a
stop and go situation, the i3s switch/indicator
can be changed to “OFF” condition. Once this
is done, the i3s system will not work and the
vehicle will be in normal operating conditions
as other vehicles and no special functions will
be performed.
If the battery voltage is low and engine r/min
is less than 2000, there will be 3 continuos
blinks after every 6 secs.
If the low battery voltage is detected while
the ignition key is in “ON” position or engine
is in running condition, the i3s function will
be deactivated or may not function properly
until the rider turns the ignition switch to
"OFF" ( ) position and then back to "ON"
( ) position.
If the vehicle is driven without battery or with
the dead battery and the engine r/min is less
than 2000 . The i3s indicator on the
speedometer will continuouslyblink at every
1.5 secs.
The i3s system will not function if rider puts
the i3s switch/indicator to“OFF” condition.
i3s function If the vehicle has fallen down,
may not work properly. B efore restarting the
engine you must turn the ignition switch to
"OFF" position and then back to "ON" ( )
( ) position.
NOTE

Related product manuals