24
•
Throttle-Check for smooth opening and
closing in all steering positions (page 41).
•
Lamps and Horn-Check that headlamp,
tail/stop lamp, turn signal lamps and horn
function properly.
•
Rear view mirror-Ensure that the rear
view mirror gives a good rear view when you
are sitting on the vehicle.
•
i3s switch/indicator-Make sure whether
the i3s switch/indicator is in “ON” or
“OFF” condition (page 16).
•
Fitting & Fasteners-Check & tighten, if
necessary.
•
Steering-Check for smooth action for
easy maneuverability.
•
i3s system-Make sure that i3s system is
functional properly (page 18).
•
Side stand indicator-Make sure that the
side stand is up. If it is in down position the
side stand indicator (page 20) will glow on
the speedometer panel.
STARTING THE ENGINE
Always follow the proper starting procedure
described below :
•
To protect the catalytic converter in your
vehicle's exhaust system, avoid extended
idling and the use of leaded petrol.
•
Your vehicle's exhaust contains poisonous
carbon monoxide gas. High levels of carbon
monoxide can collect rapidly in enclosed
areas such as garage. Do not run the engine
with the garage door closed.
•
If electric starter switch is pressed
continuously and engine does not start,
cranking of engine will stop after 5 secs.
After that rider again needs to press the
electric starter switch.
•
If engine started, cranking of the engine will
stop after r/min reaches more than 800
under normal condition.
CAUTION
!!
Preparation
•
Turn the ignition switch (1) to "ON" ( )
position.
•
Confirm that the programmed FI
malfunction indicator lamp (MIL) (2)
glows continuously and then should go
“OFF” once the engine is started.
Before starting insert the key and follow the
below mentioned procedure :
(1) Ignition switch (2) Programmed FI
malfunction indicator lamp (MIL)
2
1
To Next Page
Loading...
