23
•
Kindly ensure cable is properly placed
before placing USB charger cover
(optional) to avoid any cut in cable
•
Keep hard materials away from mobile
while placing mobile in USB charger
compartment.
•
Avoid using USB charger compartment in
wet conditions.
•
USB charger compartment is designed for
specific size of mobile excluding
accessories like, covers, etc. which might
restrict any functions.
•
Do not direct water jet towards the port even
with cap closed to avoid any short circuit.
Always dry the area using a dry cloth or
moisture free compressed air before use.
•
Any personal belongings have to be removed
before water washing to avoid damage.
•
Always keep the USB port cap closed after
use to prevent dust or water entry during
rains/water wash.
•
Do not apply any soap solution, oil or grease
inside the USB charger.
NOTE
•
Front brake (Disc type)-Check for
correct brake fluid level in the master
cylinder (page 44).
•
Fuel level-Ensure sufficient fuel is available
in your fuel tank for journey. Fuel level
segment should be above one segment
blinking (page 20). Check for leaks.
•
Rear brake- Check operation. Adjust free
play, if necessary (page 47).
•
Programmed FI malfunction indicator
lamp (MIL)-When the ignition switch is
turned “ON” the programmed FI
malfunction indicator lamp (MIL) glows
continuously and then should go “OFF”
once the engine is started.
•
Clutch-Check for smooth operation.
Adjust free play, if necessary (page 40).
minutes, and in the long run they can save
time, expense and possibly your life. Please
follow the tips as given below:
•
Drive chain-Check condition and
slackness (page 42). Adjust and lubricate,
if necessary.
•
Tyres-Check condition and pressure
(page 52).
•
Engine oil level-Check and top up engine
oil if required (page 33). Check for leaks.
•
Front and Integrated brakes (Drum
type)-Check operation. Adjust free play, if
necessary (page 46).
You should conduct pre-ride inspection
before riding the vehicle to enhance riding
comfort and safety. Clean your vehicle
regularly. It protects the surface finish. Avoid
cleaning with products that are not specifically
designed for vehicle surfaces. Inspect your
vehicle very day before you start the engine.
The items listed here will only take a few
PRE-RIDE INSPECTION
To Next Page
Loading...
