(1) Electric starter switch (2) i3s switch
Ensure starter switch (1) is operated when the
vehicle is in neutral gear. If the vehicle is
engaged in gear press the clutch lever before
operating the starter switch. Release starter
switch after the engine has started.
1. Electric starter switch ( )
Right handlebar controls
•
If engine started, cranking of the engine will
stop after r/min reaches more than 800
under normal condition.
•
If electric starter switch is pressed
continuously and engine does not start,
cranking of engine will stop after 5 secs.
After that rider again needs to press the
electric starter switch.
CAUTION
!!
2. i3s switch
There is an i3s switch provided to enable (2)
the rider for turning i3s mode “ON” or “OFF”
based on the traffic conditions.
2
1
i3s (IDLE STOP START SYSTEM)
Starting & Warm up the engine:
Turn the ignition key to “ON” ( ) position.
The i3s indicator (1) will glow on the
speedometer console for 2 seconds and turn
“OFF”. For the activation of i3s system, start
the engine and let it idle till the engine gets
warmed up or temperature reaches more than
75°C.
(1) i3s indicator
1
Initial activation of the i3s system:
Keep the i3s switch (2) to “ON” position.
Turn the ignition key to “ON” position. The
i3s indicator on the speedometer console will
glow for 2 seconds and turn “OFF”. Start the
vehicle (in neutral and clutch lever released
condition) with less than 2000 r/min and let
it idle till engine temperature reaches more
than 75°C. The engine will cut-off in 30
seconds.
23
To Next Page
Loading...
