(1) USB charger (2) Cap
(3) Inner panel
1
2
3
•
Multiple charging of USB devices have to be
avoided, simultaneous charging may lead to
slow or no charging.
•
USB port is for charging compatible USB
devices.
• Always place the device in a soft clean
cloth/towel to avoid any damage due to
road shocks while riding.
•
USB charger will not be covered under
warranty in case of USB charger cap
damage.
•
Do not leave the USB device and USB cable
in the fuel tank cover when the vehicle is
parked.
•
Charge your device only when the engine is
operational/while riding.
CAUTION
!!
PRE-RIDE INSPECTION
You should conduct pre-ride inspection
before riding the vehicle to enhance riding
comfort and safety. Clean your vehicle
regularly. It protects the surface finish. Avoid
cleaning with products that are not specifically
designed for vehicle surfaces. Inspect your
vehicle very day before you start the engine.
The items listed here will only take a few
minutes, and in the long run they can save
time, expense and possibly your life. Please
follow the tips as given below:
•
Press the cap slightly for proper locking of
USB charger cap.
•
Do not direct water jet towards the port even
with cap closed to avoid any short circuit.
Always dry the area using a dry cloth or
moisture free compressed air before use.
•
Always keep the USB port cap closed after
use to prevent dust or water entry during
rains/water wash.
•
Do not apply any soap solution, oil or grease
inside the USB charger.
•
Any personal belongings have to be removed
before water washing to avoid damage.
•
The charging time of mobile may vary,
depending on the mobile's battery state of
the charge, mobile make and conditions.
NOTE
29
To Next Page
Loading...
