•
Front brake (Disc variant)-Check for
correct brake fluid level in the master
cylinder (page 51).
•
Engine oil level-Check and top up engine
oil if required (page 41). Check for leaks.
•
Programmed FI malfunction indicator
lamp (MIL)-When the ignition switch is
turned “ON” the programmed FI
malfunction indicator lamp (MIL) glows
continuously and then should go “OFF”
once the engine is started.
•
Fuel level-Ensure sufficient fuel is available
in your fuel tank for journey (page 15).
Check for leaks.
•
Low fuel indicator-Vehicle should not be
operated with low fuel indicator glowing
continuously (page 17).
•
Front and Integrated brakes (Drum
variant)-Check operation. Adjust free
play, if necessary (page 52).
•
Rear brake- Check operation. Adjust free
play, if necessary (page 54).
•
Tyres-Check condition and pressure
(page 59).
•
Side stand-Check for proper functionality
(page 25).
•
Drive chain-Check condition and
slackness (page 49). Adjust and lubricate,
if necessary.
•
Throttle-Check for smooth opening and
closing in all steering positions (page 48).
•
Clutch-Check for smooth operation.
Adjust free play, if necessary (page 47).
•
Lamps and Horn-Check that headlamp,
tail/stop lamp, turn signal lamps and horn
function properly.
•
Rear view mirror-Ensure that the rear
view mirror gives a good rear view when you
are sitting on the vehicle.
•
i3s switch-Make sure whether the i3s
switch is in “ON” or “OFF” position (page
23).
•
i3s system-Make sure that i3s system is
functional properly (page 23).
•
Steering-Check for smooth action for
easy maneuverability.
•
Fitting & Fasteners-Check & tighten, if
necessary.
30
To Next Page
Loading...
