NOTE
Hero MotoCorp workshop for check-up.
programmed FI system. It is recommended to
started, there is an abnormality in the
reduce the speed and drive to the Authorised
If MIL remains “ON” even if the vehicle is
Ÿ Find neutral position & check neutral
N indicator (3) on instrument console
with ignition “ON”.
Preparation
Before starting insert the key and follow the
below mentioned procedure :
•
Turn the ignition switch (1) to “ON” ( )
position.
•
Confirm that the programmed FI
malfunction indicator lamp (MIL) (2)
glows continuously and then should go
“OFF” once the engine is started.
(3) Neutral indicator
3
(1) Ignition switch (2) Programmed FI
malfunction indicator lamp (MIL)
2
31
STARTING THE ENGINE
Always follow the proper starting procedure
described below :
•
To protect the catalytic converter in your
vehicle's exhaust system, avoid extended
idling and the use of leaded petrol.
•
Your vehicle's exhaust contains poisonous
carbon monoxide gas. High levels of carbon
monoxide can collect rapidly in enclosed
areas such as garage. Do not run the engine
with the garage door closed.
•
If engine started, cranking of the engine will
stop after r/min reaches more than 800
under normal condition.
•
If electric starter switch is pressed
continuously and engine does not start,
cranking of engine will stop after 5 secs.
After that rider again needs to press the
electric starter switch.
•
This vehicle is equipped with a side stand
engine kill feature (page 26).
CAUTION
!!
1
To Next Page
Loading...
