EasyManua.ls Logo

HERO PASSION XTEC - Page 35

HERO PASSION XTEC
83 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NOTE
This vehicle has a fuel-injected engine with an
idle air control valve (IACV).
Starting procedure
At any ambient temperature, Press the starter
switch with the throttle completely closed.
If the engine starts with unstable idle, open
the throttle slightly.
If the engine fails to start after repeated
attempts, it may be flooded with excess fuel.
If the engine does not start wait for 15-20
seconds, and try restarting the engine with
throttle completely closed.
Flooded engine
Your vehicle is designed to automatically stop
the engine fuel pump, if vehicle falls down.&
(Bank angle sensor cuts off the ignition).
Ignition cut off
NOTE
If the vehicle has fallen down, before restarting
the engine you must turn the ignition switch to
"OFF" ( ) position and then back to "ON"
( ) position.
Help assure your vehicle's future reliability and
performance by paying extra attention to how
you ride during the first 500 km.
During this period, avoid full-throttle starts
and rapid acceleration.
Running in
NOTE
To start the engine if any gear is engaged, press
the clutch lever and press the starter switch.
Do not open the throttle during starting the
vehicle.
WARNING
!!
Never run the engine in a closed area, the
exhaust contains poisonous gases.
32
Kick start : Depress the kick starter until
resistance is felt. Then let the kick starter
return to the top of its stroke. Kick from the
top of the stroke through to the bottom with
a rapid, continuous motion.
Electric start : Press the electric starter
switch with fully closed throttle.
(4) i3s switch
Make sure whether the i3s switch (4) is in
“ON” or “OFF” position.
4

Related product manuals