Product enclosure
•
The product contains metal, glass, plastic, as well as sensitive electronic components. If the product is dropped or burnt, stop using it
immediately and contact Hesai technical support.
•
Do NOT squeeze or pierce the product. If the product enclosure is broken, stop using it immediately and contact Hesai technical support.
•
Certain product models contain high-speed rotating parts. To avoid potential injuries, do NOT operate the product if the enclosure is loose.
•
Before operating the product, make sure it is properly and securely mounted. The mounting should prevent the product from leaving its
mounting position under external forces (such as collisions, high winds, and stone impacts).
•
If the product enclosure consists of fins or grooves, please wear gloves when handling the product. Applying too much pressure with your bare
hands may cause cuts, bruises or other injuries.
Product enclosure: cover lens
•
Do NOT apply protective film, wax or any other substance on the cover lens.
•
To keep the product's cover lens from fingerprints and other stains, do NOT touch the cover lens with bare hands. If the cover lens is already
stained, please refer to the cleaning method in the Sensor Maintenance section of the user manual.
•
To prevent scratches, do NOT touch the product's cover lens with hard or sharp objects. If scratches already exist, stop using the product and
contact Hesai technical support. Severe scratches may affect the quality of the product's point cloud data.
•
Before installing any exterior part, please ensure that each exterior part and its movable area do not overlap the Field of View (FOV) of the lidar
product.
The FOV of lidar is the spatial angular range bounded by the horizontal and vertical FOV ranges (see Section 1.4 Specifications of the
product's user manual); the distance to the origin of the lidar's coordinate system is not limited. For inquiries about the FOV, please contact
Hesai technical support.
-7-
To Next Page
Loading...
Need help?
General
