10/42
5 Error messages
5.1 MAINS RESET
• Switch off the mains switch.
• Wait for 10 seconds and then switch on the mains switch again.
5.2 Brief description
Error designation No. Brief description Page
TACHO-ERROR 01 Speedometer pulses break down during rotation 12
TACHO-ERROR 02 No speedometer pulses after start command 12
IMBALANCE (03)* Imbalance on motor axle 13
CONTROL-ERROR 04 Lid lock error, lid opened without recognizing that
motor had stopped
13
N > MAX 05 Excessive speed error, 250 RPM above n-max of
rotor
14
ROTORCODE 10 Invalid rotor code 14
MAINS INTERRUPT (11)* Mains interruption 14
VERSION-ERROR 12 Error in initialization 15
N < MIN 13 Speed error, slippage is too great 15
CONTROL-ERROR 21 Control panel – error: speed 15
CONTROL-ERROR 22 Control panel – error: I²C bus 15
CONTROL-ERROR 23 Control panel – error: display memory 15
CONTROL-ERROR 24 Control panel – error: clock timeout 15
CONTROL-ERROR 25 Control panel – error: EEPROM 15
CONTROL-ERROR 26 Control panel – error: driver defective 15
N > ROTOR-MAX --- Control panel – error: nominal speed is higher
than permitted rotor speed
or nominal RCF is higher
than permitted rotor RCF
16
* Error number will not be displayed
To Next Page
Loading...
