Hettich UNIVERSAL 320 R - Operation; Switching the centrifuge on and off; Opening and closing the lid

21 / 44
Rev.: 04 / 11.2023
AB1401en_SA
Operation
Switching the centrifuge on
Switching off the centrifuge
Opening the lid
Closing the lid
2. Check whether the mains voltage matches the specication on the
rating plate.
3. Connect the device to a standard mains socket using the mains
cable.
5.4 Switching the centrifuge on and off.
Personnel:
■
Trained user
Set the mains switch to [I] .
🡆 The buttons ash, depending on the centrifuge type.
The following indicators appear one after the other, depending on
the centrifuge type:
■ the centrifuge model and program version
■
When the lid is closed: ‘OPEN OEFFNEN’ indicator
■
When the lid is open: The last centrifugation data used.
The rotor is stationary.
Set the mains switch to [0] .
6
Operation
6.1
Opening and closing the lid
Personnel:
■ Trained user
The centrifuge is switched on
The rotor is stationary.
Press the [STOP/OPEN] button.
🡆 The lid unlocks by means of a motor.
The light on the left side of the [STOP/OPEN] button goes out.
CAUTION
Danger of crushing when closing the lid.
Danger of crushing ngers when the closing motor pulls the
lid against the seal.
− No parts of the body should be in the hazard zone of the
lid when closing the lid.
−
To close the lid, press on the lid from above.
NOTICE
Damage to the device caused by the lid slamming.
− Close the lid slowly.
−
Do not slam the lid.