Web-Based Access Control Solution
ACW2-XN
Lock not working
Key indicators
• Pressing the REX button should unlock the lock.
• Presenting an allowed card at the reader should unlock the lock.
• The associated relay LED should change state (Change from ON to OFF, or OFF to ON)
(Picture shows the Relay 1 LED in the ON State)
Analysis
• Has the relay been configured correctly in the software?
o Configure the relay correctly in the software.
• Has the relay to lock been wired correctly?
o Wire the relay to lock correctly.
• Is the Wiegand Door Module defective?
o Replace Wiegand Door Module.
• Has the correct kind of lock been used, 12V DC?
o Replace the lock with the correct kind of lock.
• Is the lock powered from the ACW2-XN?
o Is the battery voltage of the battery in the ACW2-XN, too low?
Recharge / replace the battery
• Is the lock powered from a separate power supply?
o Is the power supply that is supplying the lock, switched on?
Switch on the power supply for the lock.
o Is the power supply for the lock defective?
Replace the power supply for the lock.
To Next Page
Loading...
Need help?
General
