HID Fargo DTC1250 - Page 35

October 2013 Page 35
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
4.6.1 Safety Messages (Review Carefully)
Symbol
Critical Instructions for Safety purposes
Danger: Failure to follow these installation guidelines can result in
death or serious injury.
Information that raises potential safety issues is indicated by a
warning symbol (as shown to the left).
• To prevent personal injury, refer to the following safety
messages before performing an operation preceded by this
symbol.
• To prevent personal injury, always remove the power cord
prior to performing repair procedures, unless otherwise
specified.
• To prevent personal injury, make sure only qualified
personnel perform these procedures.
Caution: This device is electrostatically sensitive. It may be damaged
if exposed to static electricity discharges.
Information that raises potential electrostatic safety issues is
indicated by a warning symbol (as shown to the left).
• To prevent equipment or media damage, refer to the
following safety messages before performing an operation
preceded by this symbol.
• To prevent equipment or media damage, observe all
established Electrostatic Discharge (ESD) procedures while
handling cables in or near the Circuit Board and Printhead
Assemblies.
• To prevent equipment or media damage, always wear an
appropriate personal grounding device (e.g., a high quality
wrist strap grounded to avoid potential damage).
• To prevent equipment or media damage, always remove
the Ribbon and Cards from the Printer before making any
repairs, unless otherwise specified.
• To prevent equipment or media damage, take jewelry off
of fingers and hands, as well as thoroughly clean hands to
remove oil and debris before working on the Printer.