Page 50 October 2013
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
4.10 Image Calibrate
Use the Image Calibrate tab to control the position of the printable area in relation to the card.
Use the Vertical and Horizontal image position controls to adjust the position of the overall print area to be
precisely centered on a card. The maximum value for the Vertical and Horizontal adjustments is ±100 pixels
(10 pixels = about .03%, .8mm).
• Vertical – Use the Vertical adjustment to move the image toward the rear of the printer, if the
adjustment is a positive number. Enter a negative number to move the image toward the front of the
printer.
• Horizontal – Use the Horizontal adjustment to move the image toward the card output side of the
printer, if the adjustment is a positive number. Enter a negative number to move the image toward the
input side of the printer.
To Next Page
Loading...
