October 2013 Page 47
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
• Write Only – Click to use rewritable cards. The default setup is for the printer to first erase the entire
card and then write new information on the card. There is no option to select specific areas to erase.
However, to print or erase a section, use the Overlay/Print Area tab. Select the specific area in the
same manner as a print job with a color ribbon. To erase many cards, use the FARGO Workbench
Re-Writable Card Eraser option. It does not print. It only erases.
Note: No ribbon is used with rewritable cards. Do not load a ribbon intothe printer when using this
process. Printing on a rewritable card with a ribbon will ruin the card.
• Encrypt Job Data – Click to encrypt information about the print job for enhanced security.
4.9 Image Color
Use the Image Color tab to improve the quality of the image on the card. Image Color includes two areas,
Image Quality and Heat.
To Next Page
Loading...
