October 2013 Page 45
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
Standard Resin Head Adjust
Use this adjustment for Black standard resin text and barcodes if
they appear faded, too light or too dark.
Maximum Adjustment Range is +/- 100.
This control can be helpful for fine-tuning the transfer of resin text
Printhead Smart Cue Offset
Adjusts the card handling path to allow for variances in card
Enable Swift ID over USB
connection
Check this item to utilize Swift ID via a USB connection. When this
box is checked the Ethernet connection (if applicable) on the
printer will not be operational.
• If the USB selection is not be accessible, the HID EEM driver
that Swift ID uses to connect via a USB connection has not
been installed.
• This driver can be found on the installation CD or it can be
down loaded from the HID Global support page.
• The easiest method for enabling Swift ID is to un-install the
printer driver and its components and go through the
installation procedure. During installation, select the
connection type for the Swift ID application: USB or Ethernet.
4.8 Device Options
Click Device Options to display the Supplies, Dual Sided and Options areas.
To Next Page
Loading...
