HID Fargo DTC1250 - Page 44

Page 44 October 2013
© 2013 HID Global Corporation/ASSA ABLOY AB. All rights reserved.
DTC1250e/DTC1000Me/DTC4250e Card Printer User Guide, PLT-01668, 1.0
Setting
Description
Flipper Home Offset
This setting is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been calibrated
this value may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
Flipper Eject Height Offset
This setting is a calibration driven value and should not be
adjusted. If the Flipper unit is replaced and has not been calibrated
this value may need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
Mag Super-Co Voltage Offset
This option changes the voltage going the magnetic head.
This setting is factory set and should not be changed unless
directed by a technician..
Mag Medium-Co Voltage
Offset
This option changes the voltage going the magnetic head.
This setting is factory set and should not be changed unless
directed by a technician.
Head Home Offset
This setting is a calibration driven value and should not be
adjusted. If the Printhead assembly is replaced then this value may
need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician
Head Print Offset
This setting is a calibration driven value and should not be
adjusted. If the printhead assembly is replaced then this value may
need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
Head Contact Offset
This setting is a calibration driven value and should not be
adjusted. If the printhead assembly is replaced then this value may
need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
Head Queue Offset
This setting is a calibration driven value and should not be
adjusted. If the printhead assembly is replaced then this value may
need to be adjusted.
This setting is factory set and should not be changed unless
directed by a technician.
Head Card Thickness Offset
Adjusts the card handling path to allow for variances in card
thickness.
Head Smart Card Engage
Offset
Adjusts the position of the print head to allow smart card encoder
contact.
Head Mag Offset
Adjusts the printhead for magnetic encoding.
Overlay Heat Adjust
Adjusts the temperature setting for overlay film.
10 Mil Card Queue Offset
Adjusts the input queue for use with thick cards.
Erase Speed
Adjusts the speed of the erasure process.